Change gobos and Installation of 4 logos style gobo projector
Part one-How to change-gobos lens of 4 logos switch style projector?
Step 1: Screw out all the screws of the front cover of the machine.
Step 2: The GOBO piece is magnet to hold, take the GOBO piece straight Pick and take
Step 3: Load the new GOBO and turn it upside downPut it on the lamp and stick it to the magnet
Step 4: Reinstall the front cover of the machine and complete the installation.
Details:
Unscrew the 4 screws of the front cover of the machine,then remove the frot cover.Take out the 4 pieces gobo from the machine.(can be taken out directly) Then install the 4 pieces new gobo into the machine.
Attention for installing the new gobos
The gobo reverse side is facing up,the front side is facing inside.Othervise It will project the opposit pattern.
You can put the gobos into the machine directly as it can be magnetically firxed.After finishing installation of the gobo,please covering the machine front cover and note that the hole of lens should be aligned with the pasition of the lamp bead.
Then Screw the screws back into the frxing to complete the installation.(If the machine is waterproof,please do it.)
Part two-Installation
1. Drill screw holes in the positions to be installed
2. Put the explosion screw into the punched hole first
3. Align the screw hole of the machine base bracket into the threaded end of the explosion screw
Note: The diameter of the wall opening is 10 mm.
4.Screw the nut into the thread at the end of the explosion screw， until it is tightened and the installation is completed.
